Hilti SIW 18T-A, Operating Instructions Manual, Page: 20 / 24

en
12
6.1.1.1 Fitting the socket 4
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Align the hole in the side of the nut driver with the retention ball on the
square drive.
3. Push the nut driver onto the chuck until it engages.
6.1.1.2 Removing the socket 5
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the socket away from the square drive spindle.
6.1.2 Changing the socket (¾" square drive with locking pin)
6.1.2.1 Fitting the socket
6
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Place the socket on the square drive spindle of the tool.
NOTE Take care to ensure that the holes in the square drive spindle and
socket, into which the locking pin is inserted, are in alignment with each
other.
5. To secure the socket, first insert the locking pin and then fit the O-ring.
6.1.2.2 Removing the socket 7
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Remove the socket from the square drive spindle of the tool.
5. To secure the socket, first insert the locking pin and then fit the O-ring.
6.2 Setting forward or reverse rotation 8
6.3 Belt hook 9
CAUTION
Check that the belt hook is fitted securely before beginning work.
Printed: 20.05.2015 | Doc-Nr: PUB / 5136087 / 000 / 03