4 Technical data
Right of technical changes reserved.
Lamp
Voltage
Bulb
SFL 144‑A
14.4 V
Xenon 14.4V/ 0.8A
Battery
B 144/2.6 Li‑ion
Rated voltage
14.4 V
Capacity
2.6 Ah
Energy content
37.44 Wh
Weight
0.55 kg
Temperature monitoring
Yes
Type of cell
Li‑Ion
No. of cells
4
5 Safety instructions
NOTE
In addition to the safety instructions given in the various
sections of these operating instructions, the following
points must be observed at all times.
5.1 Power tool use and care
a) If the hot glass is covered by an inflammable material
it may, under certain circumstances, catch fire.
Do
not cover the lamp, do not leave it unattended
when switched on and do not touch the hot glass.
b)
Use only replacement bulbs of the type specified
by the manufacturer.
c)
Do not point the lamp toward yourself or other
persons. There is a risk of dazzling yourself or
these other persons.
5.2 Battery tool use and care
a)
Ensure the switch is in the off position before
inserting battery pack.
Inserting the battery pack
into power tools that have the switch on invites
accidents.
b)
Do not expose batteries to high temperatures or
fire.
This presents a risk of explosion.
c)
Do not disassemble, squash or incinerate batter-
ies and do not subject them to temperatures over
80°C.
A risk of fire, explosion or injury through con-
tact with caustic substances may otherwise result.
d)
Avoid ingress of dampness.
Dampness may cause
a short circuit resulting in a risk of burning injury or
fire.
e)
Do not use batteries other than those approved
for use with the applicable tool or appliance.
Use
of other batteries or use of the battery for purposes
for which it is not intended presents a risk of fire and
explosion.
f)
Observe the special instructions applicable to the
transport, storage and use of Li-ion batteries.
g)
Avoid short-circuiting the battery.
Before inserting
the battery in the tool or appliance, check that the
terminals of the battery and the tool or appliance are
free from foreign objects. Short-circuiting the battery
terminals presents a risk of fire, explosion or contact
with caustic substances.
h)
Do not charge or continue to use damaged bat-
teries (e.g. batteries with cracks, broken parts,
bent or pushed-in and/or pulled-out contacts).
i) If the battery gets too hot to touch, this may indicate
that it is faulty.
Place the tool in a location where
it can be kept under observation, well away from
flammable materials, and allow it to cool down.
Contact Hilti Service after the battery has been
allowed to cool.
en
10
Printed: 08.07.2013 | Doc-Nr: PUB / 5135045 / 000 / 01
