Hilti RC 4/36, Manual

Page: 21 / 256

*2142553*
2142553 English 17
3 Description
3.1 Overview 1
@
Display
;
Power button
=
Carrying handle
%
Antenna
&
Knob
(
Casing
)
Rubber armoring
+
Mode button
§
Preset button
/
Bluetooth button
:
Equalizer button
∙
Time settings
$
USB port
£
AUX port
|
Battery
¡
NFC interface
Q
Battery compartment
W
Supply cord holder
3.2 Intended use
Do not use outdoors.
The device is a battery charger that can simultaneously play audio received by the built-in radio or via an
AUX input.
The device can play audio from various other devices either paired via Bluetooth or connected by an AUX
cable.
The USB port can be used to charge other devices connected to this device.
The device is designed for use under jobsite conditions. It may not be exposed to moisture or water.
Operate the device only at the voltage stated on the type identification plate. When powering the device by
battery, use only the batteries specified by Hilti .
The device can be connected to a power outlet using a plug with no earth/ground contact (i.e. two-pin plug).
The battery is charged only while the device is connected to an AC supply. When the device is not connected
to an AC supply it operates under battery power.
Interference (noise) can occur when the radio is set to AM or FM frequency reception while a battery is being
charged.
3.3 Batteries
The appliance can be powered by the following Hilti batteries: B14, B18, B22, B36.
The appliance can charge the following Hilti batteries: B12 (only with adapter), B14, B18, B22, B36.
Please note the approved batteries, as stated on the type identification plate.
Printed: 20.07.2018 | Doc-Nr: PUB / 5296507 / 000 / 03