Hilti PR 30-HVSG, Original Operating Instructions

Page: 27 / 96

*2179604*
2179604 English 19
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The tool doesn’t work. The battery is not fully inserted.
▶
Push the battery in until it
engages with an audible click.
Low battery.
▶
Change the battery and charge
the empty battery.
The tool has a fault or error.
▶
Switch the tool off and then on
again. Contact Hilti Service if
the fault / error persists.
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Warm up the battery slowly to
room temperature.
The battery doesn’t engage
with an audible click.
The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and refit
the battery.
The tool or battery gets very
hot.
Electrical fault.
▶
Switch the tool off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
Serious error. All the LEDs on
the rotating laser flash.
Serious error. This message is al-
ways accompanied by the corre-
sponding symbol.
▶
Further operation is not possi-
ble. Switch off all tools / devices
and then switch them on again.
Warning
The warning message is always
accompanied by the correspond-
ing symbol.
▶
Solutions are indicated by the
corresponding symbol.
Pairing was unsuccessful.
Pairing the rotating laser and laser
receiver is not possible.
▶
Follow the instructions on
pairing the devices exactly.
Pairing was unsuccessful.
Pairing the tripod and laser re-
ceiver is not possible.
▶
Follow the instructions on
pairing the devices exactly.