![background image](http://html1.mh-extra.com/html/hilti/nun-054-ie-a22/nun-054-ie-a22_original-operating-instructions_2135085014.webp)
8
English
2188463
*2188463*
Never operate the tool without a crimping / pressing die in place.
1. Remove the battery.
2. Select a suitable crimping die. Push the two halves of the crimping / pressing die in until they engage.
5.8
Removing the crimping die (only for crimping jaws with crimping dies)
WARNING
Risk of injury!
Unintentional starting.
▶
Remove the battery before fitting, changing or removing the crimping / pressing die.
1. Remove the battery.
2. Pull back the locking mechanism and remove the two halves of the crimping die.
5.9
Changing the cutting edges
WARNING
Risk of injury!
Unintentional starting.
▶
Remove the battery before inserting, changing or removing cutting edges.
1. Remove the battery.
2. Unscrew the cutting edge securing screws.
3. Remove the cutting edges by pulling them out toward the front end of the tool.
4. Insert the new cutting edges in the tool.
5. Tighten the cutting edge securing screws.
5.10
Crimping
WARNING
Danger!
Risk of fire due to faulty crimping.
▶
Use crimping terminals of the correct type and size for the cable and with the corresponding crimping
dies. Failure to observe this point can result in faulty crimping.
▶
Listen for the signal tone and check that the piston has retracted. If no signal tone is heard or if the piston
does not retract then the crimping is faulty.
1. Insert the connector in the open crimping die.
In cold weather the hydraulic oil can thicken and slow the pressing operation. Perform 5 to 10
empty pressing operations to heat up the pressing tool.
2. Press the control switch.
3. Keep the control switch pressed until the piston has retracted.
4. Repeat the crimping operation if necessary, beginning at A and moving in the direction of arrow B,
carrying out the number of crimping operations given in the tables.
5.11
Making the cut
WARNING
Risk of injury!
Risk of serious injury during the cutting operation.
▶
Throughout the cutting operation, take great care to keep your hands and fingers well clear of the cutting
jaws.
In cold weather the hydraulic oil can thicken and slow the pressing operation. Perform 5 to 10 empty
pressing operations to heat up the pressing tool.
Summary of Contents for NUN 054 IE-A22
