![background image](http://html.mh-extra.com/html/hilti/dcg-180-d/dcg-180-d_operating-instructions-manual_2135616021.webp)
Obligation signs
Wear eye
protection
Wear a hard
hat
Wear ear
protection
Wear
protective
gloves
Wear
breathing
protection
Symbols
Read the
operating
instructions
before use
Return waste
material for
recycling.
Volts
Amps
Hertz
Watts
Alternating
current
Rated speed
Revolutions
per minute
Revolutions
per minute
Diameter
Double
insulated
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
2 Description
2.1 Use of the product as directed
The power tool is an electrically-powered angle grinder for professional use in the construction industry. The power
tool is designed for cutting, grinding and brushing metal or mineral materials (concrete, stone, etc.) without use of
water.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Working with metals: Cutting, rough grinding, fine grinding, brushing
Working with mineral materials: Cutting, slitting and grinding.
Use only grinding discs, cutting discs and other accessories of max. 180 mm diameter that are approved for use at a
speed of at least 8500 /min.
For this application, use only synthetic resin-bonded fiber-reinforced abrasive cutting discs approved for use at a
peripheral speed of at least 80 m/sec.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Modification of the power tool or tampering with its parts is not permissible.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
en
17
DCG 180-D / DCG 180-P, Art. Nr.71878/A2, 05.03.2013
Printed: 08.07.2013 | Doc-Nr: PUB / 5069492 / 000 / 01