hilscher NSCP-C100-RE\50, User Manual

Page: 54 / 71

Technical Data 54/71
netSCOPE Data Acquisition Cards for Real-Time Ethernet | Installation, Operation and Hardware Description
DOC131006UM01EN | Revision 1 | English | 2013-11 | Released | Public
© Hilscher, 2013
11 Technical Data
11.1 Technical Data netSCOPE Data Acquisition Cards
Note: All technical data are temporarily and can be altered without notice.
11.1.1 NSCP-C100-RE\50
NSCP-C100-RE\50 Parameter Value
Name NSCP-C100-RE\50
Part No. 7330.100
Description netSCOPE data aquistion card PCI for Real-Time Ethernet
Part
Function Data Acquisition Card for Real-Time Ethernet
Communication
Controller Type netX 500 processor
RAM 8 MB SDRAM
FLASH 4 MB serial Flash EPROM
Integrated Memory
Size of the Dual-Port Memory 64 KByte
Bus Type PCI, according to [bus spec 1], refer to section Overview ,
page 52.
Transmission Rate 33 MHz
Data Access DPM
System Interface
Width for the data access to the
Dual-Port Memory (DPM) 32-Bit
History depth and signal
count
Unlimited, only restricted by PC memory
Process Data Interface
Signal types Input and output process values
Supported Real-Time Ethernet
system EtherCAT
Ethernet Frame Types Ethernet II
Baud rate 100 MBit/s
Data transport layer Ethernet II, IEEE 802.3
Ethernet System
Automated symbol import EtherCAT: ENI file
Transmission rate 100 MBit/s (for EtherCAT)
Interface Type 100 BASE-TX (for EtherCAT),
refer to section
Ethernet Interface , page 50.
Galvanic Isolation isolated
Isolation Voltage 1000 VDC (tested for 1 minute)
Full duplex For EtherCAT: supported (at 100 MBit/s)
Auto-Negotiation For EtherCAT: supported
Auto-Crossover For EtherCAT: supported
Connector 2* RJ45 Socket
Ethernet channels 2x RJ45, passive TAP, Ethernet delay < 1 µs
additional external TAP with zero-delay possible
Ethernet Interface
Time-stamp resolution 10 ns
SYS System Status LED
STA0 LED Status 0 (duo LED)
Display LED Display
STA1 LED Status 1 (duo LED)