Technical Data
133/145
netRAPID Chip Carrier | Getting Started
DOC131104GS04EN | Revision 4 | English | 2017-09 | Released | Public
© Hilscher 2014 - 2017
6.2 PROFIBUS DP Slave
6.2.1
netRAPID Chip Carrier NRP 10-DPS
NRP 10-DPS
Parameter
Value
Device identification
Part number
7650.420
Communication
controller
Type
netX 10
Memory
FLASH
4 MB serial Flash EPROM
Communication interface Field bus
PROFIBUS DP Slave
PROFIBUS Interface
Transmission rate
9,6 kBit/s, 19,2 kBit/s, 31,25 kBit/s, 45,45 kBit/s,
93,75 kBit/s, 187,5 kBit/s, 500 kBit/s, 1,5 MBit/s,
3 MBit/s, 6 MBit/s, 12 MBit/s
Interface Type
RS-485
Galvanic Isolation
Isolated
Host interface
Type
Parallel Dual-port memory or serial Dual-port memory (SPI)
Dual-port memory size
16 KB (14 address lines), where 8 KB used by firmware (13
address lines, lowest 8 KB)
Data width (parallel)
8 or 16 bit
Serial dual-port memory
interface
SPI Slave, mode 3 (CPOL = 1, CPHA = 1)
Serial transmission rate
Max. 50 MHz
Connector Type
76-pin solder contacts 1 mm with 1.5 mm grid
Diagnostic Interface
USB
Signals at chip carrier (supported by standard firmware)
Available only if integrated in host system
UART
RXD, TXD signals at chip carrier
(not supported by standard firmware)
Display
LED Display
Signals at chip carrier
SYS system status
COM communication status
Power supply
Voltage
+3.3 V ± 5 % DC
Current at 3.3 V (typ.)
290 mA
Current at 3.3 V (max.)
790 mA
Power Consumption
1 W
Signal lines
Voltage of IO signal lines +3.3 V ± 5 %
Environmental conditions Ambient temperature
range for operation
-20 … +70 °C
Air flow
0.5 m/s
Dimensions
L x W x H
32 x 32 x 4 mm
Weight
Weight
approx. 3 g
Table 47: Technical data NRP 10-DPS
