Annex
173/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
11 Annex
11.1 Device Label with Matrix Code
You can identify your device by means of the device label.
Note:
The position of the device label on your device can be seen from the
device drawing.
The device label consists of a matrix code and the information contained
therein in plain text.
The 2 D code (Data Matrix Code) contains the following information:
Part number: 1234.567
Hardware revision: 1
Serial number: 20000 (for mini matrix 20001)
The device label with matrix code can be designed as mini-sticker.
Figure 55: Example 2D Label (mini sticker on the right)
11.2 Tolerances of the shown Card Dimensions
The manufacturing tolerance of the printed circuit boards of the PC card
cifX is ± 0.1 mm per milled PCB edge. For all dimensions of the PCB
indicated on the drawings (in the sections
Dimensions PC Cards cifX PCI
and PCI Express
from page 174 and
Dimensions PC Cards cifX Low Profile
PCI Express
from page 199) thus results for the length L and the width W,
a tolerance of ± 0.1 mm (per milled edge) x 2 = ± 0.2 mm.
W = [
width of the board in mm
] ± 0.2 mm
L = [
length of the board in mm
] ± 0.2 mm
The depth T of the PCB depends on the highest part used or the circuit
board plus the descenders. The thickness of the PCB is = 1.6 mm ± 10%.
Note:
The dimensions (L x W x D) specified in section
Technical Data PC
Cards cifX
on page 116 (and also the identical values in the data sheet
cifX and on the ‘Hilscher Site’) are rounded and unified for the respective
types of card. Here the depth of the PC cards PCI (CIFX 50), PCI Express
(CIFX 50E) or Low Profile PCI Express (CIFX 70E) has been equated to
the rounded width of the front panel.
