User’s Manual
V1.0
12
Data
RAID REBUILDING
When one of the installed hard disk drive fails, replace the hard disk drive with new one and RAID rebuilding
proceeds automatically.
NOTES:
RAID rebuilding is not supported for the SATA port multiplier and RAID 0 mode.
If you replace two hard disk drives at a time, RAID rebuilding proceeds sequentially one by one.
1.
When one of the installed hard disk drives fails, the beep sounds and the LEDs of corresponding HDDs
among D1 to D4 LEDs on the front panel flicker in green and red sequentially. Poke the Setup button
on the front panel with the straightened paperclip and press for 3 seconds. A beep releases.
2.
Replace the failed hard disk drive with a new one and RAID rebuilding proceeds automatically.
