Hill-Rom P2016, Service Manual

Page: 53 / 133

4.2 Electrical Device
Chapter 4: Removal, Replacement, and Adjustment Procedures
Bed Locator Service Manual (man138ra) Page 4 - 5
4
4.2 Electrical Device
Tools required: Phillips head screwdriver
Removal
WARNING:
Only qualified and authorized service personnel may remove or replace
the electrical devices on the Bed Locator. Personal injury or equipment
damage could occur.
1. Follow steps 1 through 3 of the section “Electrical Device Cover Plate” on
page 4-3.
CAUTION:
The electrical schematic in figure 3-1 on page 3-3 reflects a typical
wiring diagram for the Bed Locator. This diagram may not reflect the
actual wiring configuration of your unit. Refer to the electrical schematic
that accompanied your Bed Locator for specific electrical connection
information about your unit. Failure to do so could result in equipment
damage.
2. Remove the defective electrical device from the Bed Locator assembly.
Replacement
SHOCK HAZARD:
Refer to the electrical schematic that accompanied your Bed Locator for
actual electrical connection information. Failure to do so could result in
personal injury or equipment damage.
1. Reverse the removal procedure to replace the electrical device.
2. Replace the device cover plate by performing steps 1 through 3 of the
section “Electrical Device Cover Plate” on page 4-3 in reverse order.
3. Ensure the replacement device has electrical power. If no power is present,
verify proper electrical connections were made in accordance with the
electrical schematic that accompanied your Bed Locator.