Steps:
1.
Drill four screw holes in the wall according to the
holes of the bracket.
2.
Install the bracket to the wall by aligning the four
screw holes of the bracket with expansion screws on
the wall.
3.
Secure the bracket with four hex nuts and washers.
Type I Camera
Type II Camera
Figure 2-17
Install the Bracket
4.
Install the mounting base of the turret camera to
the wall mounting bracket, and secure them with
supplied screws.
Type I Camera
Type II Camera
Figure 2-18
Install the Mounting Base to the Bracket
5.
Route the cables through the bracket.
6.
Repeat steps 7 to 9 of 2.1.1 Ceiling/Wall Mounting
without Junction Box to complete the installation.
2.4
Ceiling Mounting of Type III Camera
Steps:
1.
Paste the dill template to the ceiling.
2.
Drill the screw holes and cable hole (optional) in the
ceiling according to the drill template.
Drill Template
Hole A: for cables routed through the ceiling
screw hole 1: for Mounting Base
1
1
1
A
Screw
Hole
Cable
Hole
Figure 2-19
Drill Template
Note:
Cable hole is required, when adopting the ceiling
outlet to route cables.
3.
Loosen the set screws with a hex wrench (supplied)
to remove the bubble.