Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
6
Specification
5
Operation Caution and Device Maintenance
- All the electronic operation should be strictly compliance with the electrical safety regulations, fire prevention
regulations and other related regulations in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation.
Avoid the equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment
damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then
please contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation.
Avoid the equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment
damage).
- Do not place the device in extremely hot (refer to the specification of the device for the detailed operation
temperature), cold, dusty or damp locations, and do not expose it to high electromagnetic radiation.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden
(ignorance can cause fire danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not
a malfunction however), and affecting the endurance of sensor at the same time.
- Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or
equivalent type only. Dispose of used batteries according to the instructions provided by the battery manufactur-
er.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situation.
5
Note:
- when the low voltage message appears there will be at least 30 days of use.
- The tag ID/PIN is a 32 bit long integer, and the variant could be 42949672956.
Frequency
868 MHz
Metod
Two-way communication
Distance
1.2 KM
Tamper Switch
1, rear panel tamper-proof
Indicator
1 status indicator(red, green, blue), and 4 area arming
indicator (blue)
Power Switch/ Learnt Button
1
Power Supply
1.5V, 3 AA batteries, (included, Capacity: 2300 mAh each)
2 years battery life span (10 times presenting each day)
Low Voltage Value
1.2 V
Voltage Range
Fully charged (new) to 1.2 V (battery)
Consumption
Max. current: 292mA
Quiescent current: 110uA
PS Type
Type C
Operation Humidity
10
％
to 90
％
Operation Temperature
﹣
10
℃
to +55
℃
(-10 °C to 40 °C EN Certified)
Classification
Use inside the supervised premises,Type: ACE
Installation
Wall mounting
Weight
124mm x 75mm x 21mm
Dimension
176g (with battery), 106.5g (without battery)
