6
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
5
Specification
4
3
Operation Caution and Device Maintenance
- All the electronic operation should be strictly compliance with the electrical safety regulations, fire prevention regulations and other related
regulations in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the equipment
installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact the service
center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid the equipment
installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
- Do not place the device in extremely hot (refer to the specification of the device for the detailed operation temperature), cold, dusty or
damp locations, and do not expose it to high electromagnetic radiation.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can cause fire
danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfunction however), and
affecting the endurance of sensor at the same time.
- Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of
used batteries according to the instructions provided by the battery manufacturer.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situation.
Set Up with App
You can view the device status including temperature, signal intensity, battery level, lid, external input, etc.,on the device page.
Tap the
button to enter the settings page.
UD25334B
RF Frequency
868 MHz
Modulation
2GFSK
Method
Two-way communication
RF Distance
800 m (open area)
12 V Input
Relay Output
Tamper Switch
Zone Input
Power Switch
1
1
1, Connects to the Battery
Series Port
2
2 (Front and Rear)
16
LED Status
3: Alarm/Tamper(Red), Fault(Amber),
Signal Strength(Green/Red)
Power Supply
100 to 240 VAC
12 V Output
2-channel
Total Consumption : 1 A
Operation temperature
Operation humidity
Dimension (W x H x D)
Weight
1K, 2.2K, 4.7K, 8.2K
EOL
975 g (without battery)
3024g (with battery)
10% to 90%
199 x 261 x 86.4mm
-10
℃
to 55
℃
