background image

1. Check Signal Strength
Enter the signal checking mode by operating on the control panel. Trigger the detector.
Solid Green for 3 s - Strong Signal
Solid Orange for 3 s - Medium Signal
Solid Red for 3 s - Weak Signal
Red light flashes for 3S - Lost Signal

2. Install the Detector
Dig the groove to disassemble the device.
Method 1: Secure the rear panel to the wall with two screws.
Method 2: Paste rear panel on the wall with the sponge tape.

Note: To make the TAMPER work properly, the thickness of the sponge tape should be no more than 1mm.
Installing with sponge tape is non EN compliant.

Close the front and the rear panel.

Note: You should install the sensor and the magnetic stick at the door or window’s edge. Make sure they are aligned with the door or window’s edge.

4

Installation

Method 1.

Method 2.

(optional)route the cable through

cable hole if external inputs required.

3

Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China

Signal Strength Test

Summary of Contents for DS-PDBG8-EG2-WE

Page 1: ...E and comply therefore with the applicable harmonized European standards listed under the EMC Directive 2014 30 EU RE Directive 2014 53 EU the RoHS Directive 2011 65 EU replacement of a battery with an incorrect type that can defeat a safeguard for example in the case of some lithium battery types disposal of a battery into fire or a hot oven or mechanically crushing or cutting of a battery that c...

Page 2: ...er on the peripheral and it will be automatically enrolled to the control panel 1 In the APP tap the icon and scan the QR code or serial No on the peripheral 2 Loosen the screw and remove rear panel 3 Power on the peripheral and it will be automatically enrolled to the control panel 3 Test 2 Hangzhou Hikvision Digital Technology CO Ltd No 555 Qianmo Road Binjiang District Hangzhou 310052 China xxx...

Page 3: ...el on the wall with the sponge tape Note To make the TAMPER work properly the thickness of the sponge tape should be no more than 1mm Installing with sponge tape is non EN compliant Close the front and the rear panel Note You should install the sensor and the magnetic stick at the door or window s edge Make sure they are aligned with the door or window s edge 4 Installation Method 1 Method 2 optio...

Page 4: ...structions provided by the battery manufacturer Do not expose the device to the corrosive gas Otherwise the equipment damage may occur Do not expose the device to the explosive situation You can add two external inputs each input can be set as NO NC TAMPER Pulse via the AX PRO client While Any of the two inputs generates an alarm event the detector reports the alarm to the AX PRO The LED keeps blu...

Reviews: