Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Product Support Team
6
2. Installation Guide
2.1 Installation for swing barrier
Swing barrier is mainly used in the entrance or exit of office building and high-end department,
below instruction is only for indoor use(better to install a shield if use in outdoor).
1
）
The barrier should be installed on the concrete or non-flammable ground, please check
with customer and site situation to confirm whether can trench on the ground for
interconnect and network cables. If not allowed, please purchase base for barriers
Standard scenario example:
2
）
Ensure the ground is smooth so the IR transmitter and receiver on both side of barrier can
work normally, same as Figure 1
；
Figure 3 IR sensor on barriers
Notes:
A.The device should be installed on the concrete surface or other non-flammable surfaces.
B.If the installation area is too close to the wall, make sure the distance between the
pedestal and the wall should be more than 120 mm, or you cannot open the pedestal top
cover.
