Access Control Terminal
·
Quick Start Guide
9
4.
Connect the corresponded cables.
5.
Align the buckle of the front cover with the slot of the
mounting base, and hang the front cover onto the
mounting base. Make sure the buckle is embedded into
the slot.
6.
Secure the front cover with inserting and tightening two
screws on the bottom of device.
Secure the Front Cover
Figure 4-3
4.2
Mounting without Gang Box
Steps:
1.
Drill 4 screw holes in the wall according to the holes of
the mounting base, and then insert expansion screws
sockets (not supplied) into the holes.
2.
Route the cables through the cable hole of the mounting
base.
3.
Align the screw holes on the base with the screw sockets
on the wall.
4.
Attach the mounting base on the wall with Inserting 4
KA4*22-SUS screws (supplied) into the 4 screw sockets.
