Quick Operation Guide of DS-9100/9000/8100/8000HFI-ST Series DVR
11
Alarm Connection
To connect alarm devices to the DVR:
1.
Disconnect
pluggable block
from the ALARM IN /ALARM OUT terminal block.
2.
Unfasten stop screws from the
pluggable block
, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight.
3.
Connect
pluggable block
back into terminal block.
RS-485 Connection
To connect RS-485 devices to the DVR:
1.
Disconnect pluggable block from the RS-485 terminal block.
2.
Unfasten stop screws from the
pluggable block
, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight.
3.
Connect
pluggable block
back into terminal block.
Note:
Make sure the pan/tilt receiver unit is connected to the T+ and T- of the DVR.
