DS-3D2228P Hardware Installation Manual
- 12 -
4
Data transmitting
TXD
Output
5
Transmission
requesting
RTS
No connect
6
Response transmitting
CTS
No connect
7
Data terminal ready
DTR
No connect
8
Signal ground
SG
GND
Note:
The console port of the DS-3D2228P switch does not support traffic control. Therefore,
you must set the option
data traffic control
to
none
when you configure the switch
with the super terminal. Otherwise, the single-pass problem will arise on the super
terminal.
Otherwise, the single-pass problem will arise on the super terminal. The cable is used
to connect the console port of the DS-3D2228P switch and the outside console
terminal device. One end of the cable is a 8-pin RJ45 plug and the other end is a
9-hole plug (DB9). The RJ45 plug is put into the socket of the console port on the
DS-3D2228P switch. The inner line connection in the cable is shown in figure 3-1. The
console cable is numbered as RLC0301.
Figure 0-5 Cable connection at the console port
Connecting Fast-Ethernet Interface
The DS-3D2228P switch has 24 10/100Base-TX ports. The indicators lie in the right
side of the frontal board of the machine box, indicating the LINK/ACT state. You can
connect other Ethernet terminal devices to the UTP port through the cut-through or
cross network cable. The numbering order of the pins in the UTP port is the same as
the console port.
