User Manual of Thermal Bi-spectrum Network Speed dome
4
Chapter 2
Network Connection
Before you start:
If you want to set the network speed dome via a LAN (Local Area Network), please
refer to
Section 2.1.
If you want to set the network speed dome via a WAN (Wide Area Network), please
refer to
Section 2.2.
2.1
Setting the Network Speed dome over the LAN
Purpose:
To view and configure the speed dome via a LAN, you need to connect the network speed
dome in the same subnet with your computer, and install the SADP or client software to
search and change the IP of the network speed dome.
For the detailed introduction of SADP, please refer to Appendix.
2.1.1
Wiring over the LAN
The following figures show the two ways of cable connection of a network speed dome
and a computer:
Purpose:
To test the network speed dome, you can directly connect the network speed dome to
the computer with a network cable as shown in Figure 2-1.
Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch or a
router.
Network Cable
Figure 2-1 Connecting Directly
© Hikvision
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]