User Manual of Network Speed Dome
© Hikvision
76
are stored in the SD card (if supported) or in the network disk.
Steps:
1.
Enter the Record Schedule Settings interface:
Configuration > Advanced Configuration> Storage > Record Schedule
Figure 7-6
Recording Schedule Interface
2.
Check the checkbox of
Enable Record Schedule
to enable scheduled recording.
3.
Set the record parameters of the speed dome.
Figure 7-7
Record Parameters
Pre-record:
The time you set to start recording before the scheduled time or
the event. For example, if an alarm triggers recording at 10:00, and the
pre-record time is set as 5 seconds, the speed dome starts to record at
9:59:55.
The Pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s,
25 s, 30 s or not limited.
The pre-record time changes according to the video bitrate.
Post-record:
The time you set to stop recording after the scheduled time or
the event. For example, if an alarm triggered recording ends at 11:00, and the
post-record time is set as 5 seconds, the speed dome records until 11:00:05.