PA4 × 10
Junction Box Cover
Installation Plate
Figure 2-10
Fix the Camera to the Junction Box
For Type IV and Type V camera:
Junction Box Cover
Installation Plate/Base
PM3 × 13
M4 × 10
Figure 2-11
Fix the Camera to the Junction Box
7.
Route the cables through the bottom cable hole or
the side cable hole of the junction box.
8.
Refer to Step 5 of Section 2.2.1 to adjust the angle
and finish the installation.
2.2.3
Wall Mounting
Before you start:
You need to purchase a wall mount in advance.
Steps:
1.
Drill Φ 10 mm screw holes in the wall where you
want to install the wall mount.
2.
Use four M6 expansion bolts to fix the wall mount
onto the wall.
Figure 2-12
Fix the Wall Mount
3.
Fix the base/installation plate to the wall mount.
For Type III and Type V camera:
i.
Use three PM4 screws to fix the installation plate
onto the wall mount.
