Terminal Box
·
Installation Guide
26
2).
Repeat above steps to route source cables through the
opposite “Camera” end, connect wires, install a RJ45 head and
plug it to RJ45②.
6.
Screw the cover back to terminal box.
1).
Check to ensure the O-shape ring stays in terminal box.
2).
Align the locating hole of the cover with the locating pin on
box, and gently lower the cover back to the box.
Note:
When lowering the cover, prevent the explosion suppression
surfaces from bump or scratch.
3).
Tighten the screws (torque 1.2 Nm).
Locating Hole
Locating Pin
O-Shape Ring
Explosion Suppression
Surface
Torque 1.2 Nm
Figure 3-15
Install Cover Back