E Series Network Speed Dome
·
Quick Start Guide
11
Ceiling
Toggle
Figure 2-12
Install the Speed Dome to the Ceiling
4)
Secure the bubble to the back box with three screws as shown in Figure 2-13.
Screws
Figure 2-13
Secure the Bubble
6.
Route the cables through the ceiling.
7.
Remove the protective film on the bubble after the installation is finished.
2.1.3
Ceiling Mounting
Notes:
The thickness of the ceiling must range from 5 mm to 40 mm.
The ceiling must be strong enough to withstand more than four times the weight of
the speed dome and the accessories.
If the speed dome is installed to the wooden ceiling, use the self-tapping screws to
secure the mounting base.
If the speed dome is installed to the cement ceiling, drill three Φ5 mm screw holes
onto the ceiling according to the position of the holes, and then secure the
mounting base to the ceiling with expansion screws.
Steps:
1.
Disassemble the speed dome.
1)
Loosen three screws and remove the bubble.
2)
Remove the protective lens cover, foam, and sticker.