7
English
NAMES OF PARTS (Fig. 1–Fig. 11)
Hammer case
Latch
Guide sleeve
Pilot lamp
LED light
Driver bit
Trigger switch
Display panel
Battery
Remaining battery
indicator switch
Handle
Remaining battery
indicator lamp
Push button
Hook
Motor
Screw
Housing
Groove
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WH18DA: Cordless Impact Driver
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V
Rated voltage
n
0
No-load speed
min
-1
Oscillation per minute
S
Small screw
Ordinary bolt
H
High tension bolt
MT
Tightening torque (Maximum)
Hex. drive size
kg
Weight*
(According to EPTA-Procedure 01/2014)
Disconnect the battery
Switching ON
Switching OFF
Clockwise rotation
Counterclockwise rotation
* Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
Battery
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn o
ff
the LED light, the light goes o
ff
automatically in about 3 seconds.
STANDARD ACCESSORIES
In addition to the main unit (1), the package contains the
accessories listed on page 160.
Standard accessories are subject to change without notice.
APPLICATIONS
○
Driving and removing of machine screws, wood screws,
tapping screws, etc.
SPECIFICATIONS
The speci
fi
cations of this machine are listed in the table on
page 160.
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
00Book̲WH18DA.indb 7
00Book̲WH18DA.indb 7
2021/09/29 15:48:03
2021/09/29 15:48:03
