7
●
Regarding the temperatures and charging time of the battery.
The temperatures and charging time will become as shown in
Table 2
Table 2
Charger
Battery
UC18YFSL
UC18YML2
(AC/DC)*
1
UC18YSL3
Charging voltage
V
14.4V
-
18V
Weight
kg
0.5
0.7
0.6
Temperatures at which the battery can be
recharged
0
o
C – 50
o
C -10
o
C – 50
o
C
Charging time for battery capacity, approx.
(At 20
o
C)
1.3Ah
1.5Ah
2.0Ah
2.5Ah
3.0Ah
4.0Ah
5.0Ah
6.0Ah
Min.
Min.
Min.
Min.
Min.
Min.
Min.
Min.
20
22
30
35
45
60
75
90
20/50
22/60
30/80
35/100
45/120
60/160
75/200
90/240
15
15
20
25
20
26
32
38
Number of battery cells
4 – 10
*
1
AC power supply / DC 12V (in-car) power supply
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
<UC18YML2>
Especially, using a DC 12V in-car power source may
require longer recharging time at high temperatures.
CAUTION
When the battery charger has been continuously used,
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
4. Disconnect the charger’s power cord from the
receptacle or cigarette lighter socket.
5. Hold the charger
fi
rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
CAUTION
○
If the battery is charged while it is heated because it has
been left for a long time in a location subject to direct
sunlight or because the battery has just been used, the
pilot lamp of UC18YML2 charger lights up green, or the
pilot lamp of UC18YFSL charger lights for 1 second,
does not light for 0.5 seconds (o
ff
for 0.5 seconds), or
the charge indicator lamp of UC18YSL3 charger lights
for 0.3 seconds, does not light for 0.3 seconds (o
ff
for 0.3
seconds). In such a case,
fi
rst let the battery cool, then
start charging.
○
When the pilot lamp or charge indicator lamp
fl
ickers in
red (at 0.2-seconds intervals), check for and take out
any foreign objects in the charger’s battery connector. If
there are no foreign objects, it is probable that the battery
or charger is malfunctioning. Take it to your authorized
Service Center.
○
Since the built-in micro computer takes about 3
seconds to con
fi
rm that the battery being charged with
charger is taken out, wait for a minimum of 3 seconds
before reinserting it to continue charging. If the battery
is reinserted within 3 seconds, the battery may not be
properly charged.
○
Check the voltage of the in-car power source when
the pilot lamp
fl
ickers in green (every 0.2 seconds)
continuously. (UC18YML2)
If the voltage is 12V or lower, it indicates that the car
battery has weakened and cannot be charged.
○
If the pilot lamp or charge indicator lamp does not blink
in red (every second) even though the charger cord
or cigarette lighter connecting plug is connected to
the power, it indicates that the protection circuit of the
charger may be activated.
Remove the cord or plug from the power and then
connect it again after 30 seconds or so. If this does not
cause the pilot lamp or charge indicator lamp to blink
in red (every second), please take the charger to the
HiKOKI Authorized Service Center.
MOUNTING AND OPERATION
Action
Figure
Page
Removing and inserting the battery
1
10
Charging
2
10
Installing / Removing the side handle
3
10
Tightening torque adjustment
4
10
Selecting the drill position
5
11
Selecting the impact position
6
11
Change rotation speed
7
11
Removing and mounting the hook
8
11
Remaining battery indicator
9
11
How to use the LED light
10
11
Mounting the bit
11
12
Reversing the rotational direction
12
12
Switch operation
13
12
Check and replacing the carbon brush
14
12
Charging a USB device from an
electrical outlet
15-a
13
Charging a USB device and battery
from an electrical outlet
15-b
13
How to recharge USB device
16
13
When charging of USB device is
completed
17
13
Selecting accessories
―
14
0000Book̲DS14DSDL.indb 7
0000Book̲DS14DSDL.indb 7
2017/12/05 18:21:45
2017/12/05 18:21:45
