HIKOKI DS 36DAX, Handling Instructions Manual

Page: 15 / 24

15
Information concerning airborne noise and vibration
The measured values were determined according to
EN62841 and declared in accordance with ISO 4871.
Measured A-weighted sound power level:
91 dB (A) (DS36DAX)
100.5 dB (A) (DV36DAX)
Measured A-weighted sound pressure level:
80 dB (A) (DS36DAX)
89.5 dB (A) (DV36DAX)
Uncertainty K: 5 dB (A).
Wear hearing protection.
Vibration total values (triax vector sum) determined
according to EN62841.
Drilling into metal:
Vibration emission value
a
h
, D < 2.5 m/s
2
(DS36DAX, DV36DAX)
Uncertainty K = 1.5 m/s 2 (DS36DAX, DV36DAX)
Impact drilling into concrete:
Vibration emission value
a
h
, ID = 10.3 m/s
2
(DV36DAX)
Uncertainty K = 1.5 m/s 2 (DV36DAX)
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom Possible cause Remedy
Tool doesn’t run No remaining battery power Charge the battery.
Battery isn’t securely attached. Push in the battery until a click is heard.
Tool suddenly stopped Tool was overburdened Remove the cause of the overburdening.
See “Reactive force control”.
Reactive force control was activated
Battery or tool overheated
Allow the tool and battery to thoroughly cool.
Tool bits
-can’t be attached
-fall o ff
The shape of the attachment portion doesn’t
match
The chucking diameter of the keyless chuck
is 1.5 mm to 13 mm. Use a bit that falls
within the stated range.
The lock of the keyless chuck is worn Contact a HiKOKI Authorized Service
Center and arrange to have the old keyless
chuck replaced with a new one.
Switch can’t be pulled Forward/reverse selector button is
positioned halfway
Press the button fi rmly into position for the
desired direction of rotation.
Screw head slips or comes
loose.
Bit number doesn’t match with the screw
size
Install a suitable bit.
The bit is worn Replace with a new bit.
Holes can’t be smoothly
drilled.
The drill is worn Replace with a new drill.
Rotation speed isn’t appropriate Adjust the rotation speed (HIGH/LOW) to
match the material to be drilled.
The drill is rotating in reverse Switch to forward rotation.
Battery cannot be installed Attempting to install a battery other than that
speci fi ed for the tool.
Please install a multi volt type battery.
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
They may also be used in a preliminary assessment of
exposure.
WARNING
○ The vibration and noise emission during actual use
of the power tool can di ff er from the declared total
value depending on the ways in which the tool is used
especially what kind of workpiece is processed; and
○ Identify safety measures to protect the operator that are
based on an estimation of exposure in the actual conditions
of use (taking account of all parts of the operating cycle
such as the times when the tool is switched o ff and when it
is running idle in addition to the trigger time).
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci fi cations herein are subject to
change without prior notice.
0000Book̲DS36DAX.indb 15 0000Book̲DS36DAX.indb 15 2021/04/15 14:21:27 2021/04/15 14:21:27