20
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Possible cause
Remedy
Tool doesn’t run
No remaining battery power
Charge the battery.
Battery isn’t fully installed.
Push the battery in until you hear a click.
Tool suddenly stopped
Tool was overburdened
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Battery or tool overheated
Allow the tool and battery to thoroughly cool.
Blade
- can’t be attached
- fall o
ff
The shape of the attachment portion doesn’t
match
Use the appropriate blade
(See “Selecting accessories”)
The lever is open.
Close the lever.
There is foreign matter inside the blade
holder.
Remove the foreign matter.
Switch can’t be pulled
Lock-o
ff
button is pushed in.
(CJ36DA)
Release the Lock-o
ff
button.
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
The trigger switch is being pulled only
slightly.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Blade wears out too
quickly.
Number of strokes is too fast
Switch the dial to a lower setting than the
current one.
(Switch to low speed mode when cutting
stainless steel plates)
(See “Adjusting operating speed”)
Proper machine oil not used when cutting
metallic materials
Use machine oil (turbine oil, etc.)
Too much applied pressure during operation During operation, lighten the applied
pressure.
Unable to properly cut.
Blade is inappropriate for the quality and
thickness of the material to be cut
Use the proper blade
(See “Selecting accessories”)
Speed and orbital position are inappropriate
for the quality and thickness of the material
to be cut
Set the appropriate speed and orbital
position
(See “Adjusting operating speed”)
Blade is worn, degraded or damaged
Replace with a new blade.
Battery cannot be installed Attempting to install a battery other than that
speci
fi
ed for the tool.
Please install a multi volt type battery.
0000Book̲CJ36DA̲AUST.indb 20
0000Book̲CJ36DA̲AUST.indb 20
2019/08/05 5:47:14
2019/08/05 5:47:14
