7
(1)
Connect the machine head and the control box with cables as shown on the figure.
(2)
Hold the dangling cables under the table with accessory tie holders and cord ties.
(3)
At this time, please check whether the cables are not pulled when tilting the sewing machine.
(4)
Control box back and socket as shown on the below figure
(5)
Printed circuit board wiring as shown on the below figure
Control signal
one/two (X13)
interface
Electromagnet
output (X9) interface
Pneumatic
feet solenoid
valves
interface
Upper thread tension
Electromagnet interface
The Y axis detector
interface
Stop switch interface
Trimming thread
electromagnet interface
The X axis detector
interface
Cylinder
Magnetic
switch
interface
Summary of Contents for HLK-03
