HIGHLEAD GC20618 Series, Instruction Manual Parts Catalog

Page: 10 / 54

—
7
—
5
．
Adjustment of feed (stitch) length and stitch reversing (touch back)
Note: To make feed (stitch) length smaller, depress the feed reverse lever and set the feed
length setting dial to a desired position
Touch-back button . . . Direction of stitching can be reversed by depressing this button.
Stitching goes on in reversed direction while the button is held down, and returns to forward
direction when the button is released. .
6
．
Setting of bobbin
a) Pulling out 5.cm thread tail from the bobbin.
b) Hold the bobbin so that the bobbin thread is
would in right direction and put it into the hook.
7
．
Threading of bobbin threads
a) Put the hook into the bobbin case and press down
the latch
①
.
The thread end should be left on the bed .
b) While holding the two needle Threads by left
hand, rotate the hand-wheel one turn by right
hand.
By pulling up the needle threads, as shown
in the figure, the bobbin threads will be lifted.
Each combination of bobbin thread and needle
thread should be aligned and led backward.