background image

Harness Contents

- 12 ft. (3.7 m) Harness Webbing 
   with Center Grommet
- 1 ea. Crotch Strap with  
   SS Adjuster (HL810)
- 1 ea.  SS Harness Buckle (HL414)
- 4 ea. SS Serrated Stay (WK-SS)
- 4 ea. SS D-ring (HL918)

1.  Position the webbing so that the 

center grommet is on the upper 
half. Align the grommet over the 
middle of the 3 bolt holes on the 
backside of the plate.

 

 

2.  Insert each end of the webbing 

through the angled slot adjacent 
to the bolt holes. Next, pass each 
end of the webbing through the 
horizontal slot immediately above. 
Pull the webbing tight. Be sure to 
keep the alignment between the 
grommet and the center bolt hole 
(Fig. 2a & 2b).

 

 

3.  Install shoulder D-rings. Using 

a 3-bar slide, install a D-ring on 
each shoulder approximately 
10–12 in. (25–30 cm) down from 
the plate (Fig. 3). Final position-
ing of the hardware occurs at the 
end of the process.

 

4.  Leaving an estimated amount 

of room for your shoulders, 
bring the webbing straight down 
towards the pair of angled slots 
in the bottom corners. Rotate 
the end of the webbing 90º (as 
you look at the front of the plate, 
clockwise for the left webbing 
and counterclockwise for the 
right) and insert it through the 
inner angled slot and then back 
through the outer angled slot 
(Fig. 4a & 4b).

 

 

 

Fig. 1

Fig. 2a

Fig. 2b

Fig. 3

Fig. 4a

Fig. 4b

Reviews: