APPLIANCE OPERATION MANUAL
7-
GAS CONTROLS - Lighting Procedure
1.
Select the control knob corresponding to the burner you wish to use, press down and turn the knob to the
position shown below.
2.
Press and hold the control knob down firmly for a full 5 seconds to ensure the flame failure device engages.
If the flame goes out after you release the knob then the flame failure device did not engage – simply press
down the knob firmly again turn to max position and keep pressing for a full 5 seconds.
MAINTENANCE SCHEDULE
The appliance should be kept in a clean condition and you should ensure that removable parts are correctly
reassembled. If the appliance has not been used for a long period of time check the appearance and the general
performance of the burners. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or authorized person in order to avoid a hazard. In any event the appliance should be checked by a
qualified person every five years and / or you should contact your dealer for any recommended maintenance.
GENERAL ASSEMBLY PROCEDURE FOR
INSTALLATION
PLEASE READ AND KEEP FOR FUTURE REFERENCE
NOTE:
ALWAYS ENSURE ALL PARTS ARE CLEAN AND DRY PRIOR TO OPERATING ANY
BURNER.
It is important that the burner assembly sequence on the previous page is performed
prior to initial operation of the cook top or light back may occur which could affect
the burner.
WHEN INSTALLED IN A CARAVAN OR MARINE CRAFT DO NOT USE THIS APPLIANCE AS
A SPACE HEATER. DO NOT PLACE COMBUSTIBLE MATERIAL OR PRODUCTS ON THIS
APPLIANCE AT ANY TIME. DO NOT USE AEROSOLS NEAR THIS APPLIANCE WHILST IT
IS IN OPERATION.
NOTE:
BURNERS WILL IMMEDIATELY BEGIN SPARKING VIA THE ELECTRONIC IGNI-
TION SYSTEM WHEN ANY OF THE GAS CONTROLS ARE DEPRESSED. IF THERE IS NO
IGNITION SPARK THEN THE APPLIANCE MAY NOT HAVE THE POWER TURNED ON.
CHECK THE POWER POINT AND CONFIRM THE UNIT HAS POWER.
MAXIMUM POSITION-
WOK BURNER CONTROLS
MAXIMUM POSITION- A,
B AND C BURNER
CONTROLS
ADJUSTMENT RANGE FOR
OUTER BURNER OPERATION-
WOK BURNER
ADJUSTMENT RANGE FOR
INNER BURNER OPERATION-
WOK BURNER
ADJUSTMENT RANGE FOR
BURNER OPERATION- A, B
AND C BURNERS
