High Tech IVC-45L, Manual

Page: 11 / 12

18
To clean the filter element thoroughly, remove the filter element for cleaning.
Press emergency stop button and unplug power supply to stop the machine
. Adjust
the device to transportation position.Loosen the three tower buttons on the filter
cover and turn the filter counterclockwise to remove it.
5.4 Overloading Protection
The electric control box is equipped with a thermal relay. When the current exceeds
the set value, it will enter the overload protection . In this case, just open the electric
control box and press the reset button to solve it.
5.5
Maintenance items
Any repairs must be performed by Pantheon Service Center training service
personnel and use original
Pantheon accessories. If your machine needs repair, please contact with your
retailer.
This chapter describes some of the possible failures and how to handle them. If you
still cannot resolve or have an error , please contact your nearest retailer .
Problem Possible reason Solution
Machine cannot start
The machine does not receive
or output power
Connect the power cable to
machine and start up
Motor protecting has tripped For the operation steps,see 5.5
Overloading Protection
Cable damages Contact a licensed electrician
Control circuit damage Contact a licensed electrician
or Pantheon Service center
The vacuum cleaner stops
after starting
Some objects obstruct airflow Clean hoses, filters etc.
Relay overload protection For the operation steps,see 5.5
Overloading Protection
The machine uttered a low
buzz when turn on and turn
off
Phase lost input, currently only
two phase inputs. Turn off the
machine to avoid burning the
motor .
Contact a licensed electrician
or check the input power has
three -phase input.
Dust in the motor impeller Contact a licensed electrician
Motor burned down . Contact a licensed electrician
or Pantheon Service center
The machine is blowing, not
sucking .
Phase relay failure
Contact a licensed electrician to
adjust the position of L1 and L3
wires on the power plug and
replace the phase relay if
necessary.
Poor suction performance Maybe that the vacuum system
is not sealed .
Check and repair the seal.
Cyclone separator or filter Use a compressed air or brush
to clean the cyclone and filter.
Hose blockageis not sealed . Shake suction pipe wavily
The machine is blowing
dust
Incorrect installation of the filter Install the filter correctly
Filter has been dislocated Reinstall the filter
The filter is broken Replace with new filter
Cyclone separation bucket
does not work
The dust is too light and too
thin
Cyclone blockage
Clean the cyclone( see above).
6. Frequently Asked Questions & Solutions