15
Instructions for use
GB
8 Cleaning and user maintenance
WARNING!
Risk of electric shock!
Always switch off and unplug the appliance before cleaning it or performing maintenance.
Never hold the main unit and battery under water or immerse the appliance in water or other
liquids.
NOTE!
Do not use soap or detergent to clean the premotor filter or HEPA filter because this will damage the
filter.
Allow the filter to dry naturally in the air. Do not use a hair dryer or other appliance to dry it.
Do not use any aggressive or abrasive cleaning agents to clean the housing. They could damage the
surface. Clean the housing with a damp, soft cloth when necessary.
Cleaning the dust container and cyclone filter
The dust container can be detached from the main unit for thorough
cleaning.
First open the dust container and remove the cyclone filter by
twisting it in an anti-clockwise direction and pulling down. Close the
dust container and press the release button on the main unit’s base.
Hold the button down, tip the dust container away from the main
unit and remove it with your other hand.
To insert the dust container back into the main unit connect it at the
top front side first (ensure that you have positioned it correctly).
Then press it into the main unit until you hear it click into place and
replace the cyclone filter. Observe the markings on the filter and
inside the dust container.
Clean the dust container with a brush or damp cloth.
There are power cables for the motorised power brushes inside the
dust container. Take care not to get them wet when you clean the
dust container.
The cyclone filter can be cleaned with a brush or under running
water, if necessary.
Summary of Contents for Invictus X7
Page 1: ...13 Piece Kit Instruction Manual ...
Page 21: ...21 ...