2-4
Installing the Fixture
Ecodome
®
User Manual
5
If you are installing a Studio Spot 575 or Studio Spot 250 fixture, you must
attach a light block to
each side
of the fixture. The light blocks will prevent
damage to the inside of the Ecodome housing.
Caution: Failure to install light blocks will result in damage to
the Ecodome Housing.
Using a 3/32" allen wrench (for Studio Spot 575 fixtures) or a #2 Phillips-head
screwdriver (for Studio Spot 250 fixtures), remove the two
outer
screws on
the bottom of the fixture’s yoke. Insert an 8-32 pan head screw in each outer
screw hole on the bottom of the fixture’s yoke.
Do not fully tighten the screws.
Install the light block by placing the large ends of its keyhole slots over the
two 8-32 pan head screws on the fixture’s yoke. Lightly press down on the
light block until the screws are in the small end of the keyhole slots. Tighten
the screws securely.
Studio Spot 575
Studio Spot 250
Replace the outer screws on the bottom of the fixture's yoke
Install the light block
