Malfunction:
no function
Reason:
Remedy:
1. The power supply connection of the device is not correct.
Recheck
2. The cables have no mechanical or electrical contact.
Recheck
3. The remote turn-on connection from the headunit to the amplifier is not correct.
Recheck
4. The high level inputs (from the head unit) are not connected correct and AUTO TURN ON is activated.
See page 20
5. By using the AUTO TURN ON function the button INPUT LEVEL MODE is not in HI position and the button
Set buttons to HI and ON
AUTO TURN ON not in ON position or the headunit is not equipped with ”High Power” outputs.
See page 20
6. Defective Fuses. In case of replacing the fuses, attend by any means the correct fuse rating.
Replace Fuses
Malfunction:
no signal on loudspeakers, but power LED lights up
Reason:
Remedy:
1. The connection of the speakers or the RCA audio cables is not correct..
Recheck
2. The speaker cables or the RCA audio cables are defective.
Replace cables
3. The loudspeakers are defective.
Replace speakers
4. High pass controller (Subsonic Mode) in LP/BP operation is adjusted to high.
Turn down controller
5. No signal from headunit.
Check headunit settings
Malfunction:
one or more channels/controllers are without function / faulty stereo stage
Reason:
Remedy:
1. The balance or fader controller of the headunit is not in the zero-position.
Turn to zero-position
2. The connection of the speakers is not correct.
Recheck
3. The loudspeakers are defective.
Replace speakers
4. High pass controller in LP/BP operation is adjusted to high.
Turn down controller
Malfunction:
distortions on the loudspeaker’s signal
Reason:
Remedy:
1. The loudspeakers are overloaded.
Turn down the level
Turn down the level on the headunit
Switch off loudness on the headunit
Reset bass EQ on the headunit
Malfunction:
No bass or stereo sound
Reason:
Remedy:
1. Interchange of loudspeaker cable polarity positive (+) and negative (-).
Reconnect
2. The RCA audio cables are loose or defective.
Reconnect or replacing the cables
Malfunction:
amplifier runs into protection mode (red protection LED lights up)
Reason:
Remedy:
1. Short circuit on the loudspeakers or cables.
Reconnect
2. Overheated by too low speaker impedance.
Choose a higher impedance
Use a new speaker setup
3. Insufficient air circulation by a inappropriate mounting position of the amplifier.
Change the mounting position
Ensure air circulation
4. Overloaded by insufficient power supply (too thin profile section on the power cables).
Use a bigger profile section
Malfunction:
hiss or white noise on the loudspeaker’s signal
Reason:
Remedy:
1. The level controllers are turned up.
Turn down the level
2. The treble controller on the headunit is turned up.
Turn down the level on the headunit
3. The speaker cables or the RCA audio cables are defective.
Replacing the cables
4. The hissing is caused by the headunit.
Check the headunit
26
ENG|
TROUBLE SHOOTING
Summary of Contents for Titan TSi600-IV
Page 11: ...11 NOTIZEN DE...
Page 24: ...24 ENG NOTES...
