2. Installation
2.1 Preparing to Installation
2.2 Installation Notes
1. Consult the local Government Building Department to be certain that the pool's electrical
system meets all applicable requirements.
2. This light is designed to be used in new pools and/or pools with existing same swimming
lights that need replacement.
3. This light can be installed in both concrete pool and vinyl pool.
4. Use only good quality stainless steel screws or screws provided along with the light.
5. The light must be used or operated while fully submerged underwater only. Never switch on
the light if it is not underwater.
1. Make sure to install the niche/housing on a vertical wall of the pool.
2. Make sure the top of the light should be at least 450mm below normal water surface.
3. Reserve at least 150mm long backup wire wrapping on the back of the light, for the
convenience of replacing.
4. The junction box or the 12V low voltage transformer, should be located at least 300mm
above the water surface, at least 200mm above the ground, and at least 1200mm from the
edge of the pool.
5. The light fixture and all metal parts that are within 250cm of the pool must be properly
protected with non-ductile materials and that the connections must be waterproof.
6. To achieve synchronization, make sure all the lights are installed correctly on model and
characteristics as the one being replaced.
2
