Hidro-Water KOBE WS1CI UF, User& Installer'S Manual, Page: 8 / 19

14 15
SET TIME
TIME
CAPACITY REMAINING
M
3
TIME
L
MIN
MA-EN-DESCALCIFICADOR KOBE (USR) UF-3004-XX JD18V01 MA-EN-DESCALCIFICADOR KOBE (USR) UF-3004-XX JD18V01
The transformer comes pre-installed from the factory. Check that it is correctly connected to
its connector as shown in the images and plug it into the mains.
This process can be repeated whenever necessary just by starting from the service screen by
pressing at any moment.
Once the correct hydraulic installation has been checked and the power cable is connected to the
230V ac - 50 Hz mains, in a socket that is not controlled by a switch, the valve will be programmed.
When the equipment is electrically powered, the installed software version will appear on the screen.
The valve motor will move to confirm the position of the service, and will then show the time of day
intermittently, indicating that it should be checked if it is on time and adjusted.
6.1.- Button functionality
6.2.- Setting the time
6.- PROGRAMMING - USER LEVEL / INSTALLER
Button Name Function
SET
CLOCK
Set CLOCK
Opens ‘set the time’
mode
NEXT
NEXT Confiirm and move on
REGEN
REGEN
Start regeneration / Go
back to the previous
parameter
UP/DOWN
ARROWS
Increase or decrease
the value
Press The hour will flash
Set the hour with the arrows
Press The minutes will flash
Set the minutes with the arrows
Pressing , again will take you to the service
screen
6.3.- Service screen
During the service stage, the valve screen will show us different information. This information
can be alternated by pressing the button.
This screen shows us the time of day. On some
occasions, the word
SOFTENING
will appear
intermittently on this screen. This means that the
softener is supplying water at that exact moment.
On other occasions, the word REGEN TODAY may
appear. This means that throughout that day a
regeneration will be carried out at the programmed
regeneration time (normally at 2:00 am).
During consumption, the screen will show us the
instant flow that is passing through the valve.
SET
CLOCK
SET
CLOCK
NEXT
NEXT
NEXT
This screen shows us the system’s capacity. It’s
the water available to be softened until the next
regeneration.