VertX V100 (CS) Quick Installation Guide
August 2005
Page 5 of 9
2005 © HID Corporation. All rights reserved.
Pin #
P7
1 +12VDC
2 Ground
3
Bat Fail -
4
Bat Fail +
5
AC Fail -
6
AC Fail +
7 Tamper
-
8 Tamper
+
Pin #
V100 P1
V100 P4
1
Reader Power
Shield Ground
2 Ground
Hold
3
Data 0 / Data
Beeper
4
Data 1 / Clock
Red LED
5
Data Return
Green LED
6
Green LED
Data Return
7
Red LED
Data 1 / Clock
8
Beeper
Data 0 / Data
9 Hold
Ground
10
Shield Ground
Reader Power
Step 2 Hardware Installation
2.1 Mounting
Instructions
1. The V100 should always be mounted in a secure area.
2. Mount the V100 using the four mounting screws (provided) or other appropriate fasteners. Place the
fasteners in the corner holes of the base.
3. The V100 panel can be stacked with or without the cover. Do not remove the plastic base. Make sure
to position the V100 panel in such a way as to provide room for wiring, air-flow and cable runs.
2.2 Wiring
VertX
1.
Power and Alarm input connections:
Connect power by providing 12VDC to the
P7
connector.
+12VDC goes to
Pin 1
and Ground on
Pin 2
. The Bat Fail, AC Fail, and Tamper switch inputs are
wired as shown in the table. Connect the Bat Fail and AC Fail inputs to battery low/failure and AC
failure contacts provided on the power supply. Connect the Tamper input to a tamper switch on the
enclosure.
2.
Reader Connections
: Connect Wiegand or
clock-and-data interfaces to the V100 using
the connection table shown. You can
connect up to 10 signal lines for the reader.
Use as many of the signal lines as required
for your reader interface.
Note:
Connect the data return line to the
same ground as the reader power if the
reader is not powered by the VertX units
12VDC.
CAUTION: Connectors on the V100 sides are positioned to be mirror images and are not
interchangeable once the installation is complete. Therefore, you cannot unplug the connector from
one side of the board and plug it into the corresponding connector on the other side.
