7. Assemble
9
8
Before you begin: Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents, or kinked cables that may have occurred during shipping. Because
the electric scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
Hiboy recommends assembly by an adult with experience in bicycle mechanics.
Need Help? Please search “Hiboy us” on Youtube website to find our Channel. You can watch the Installation video
of ECOM 14. Or contact Hiboy after-sale team by email: [email protected].
Need Help? Please search “Hiboy us” on Youtube website to find our Channel. You can watch the Installation video
of ECOM 14. Or contact Hiboy after-sale team by email: [email protected].
Unfold the Scooter
Open the folding lock
Required Tools: 5 mm Allen Wrench (included)
Attaching the Handlebars
1. Loosen the screw on Top of T-tube
2. Put the handle bar on(the thread
part should be in the middle)
3. Tighten the screw
Note:Please lock the brake cables with
the black latch on the T-tube (to prevent
the cables clutter)
Required Tools:16mm Wrenches*2(Included)
Attaching the Front Wheel
1.Remove axle nuts (A) and washers (B)
from the axle bolt (C)
2.Pull axle bolt(C) out of the front fork
3.Discard the black latch(D)
4.The drum brake is aligned with the
middle of the front wheel
Note: the drum brake cable should be
placed in the front fender connecting rod
5.Insert the front wheel into the
front fork
6.Insert the axle bolt (C) into the middle
hole of drum brake, tighten the axle nuts
(A) and washers (B) on two sides
Required Tools:10mm
Wrenches(Included)
Attaching the Seat Cushion
1. Unscrew nuts(E) under the seat cushion
2. Aim for the holes in the seat
3. Tighten the nuts(E)