HiBoost F20-5S, User Manual

Page: 19 / 24

19
perfect working status which means the booster has full output power that can
have optimal coverage.
LED Status Meaning Solution Methods
1. Adjust antennas' directions or locations to lower down receiving signal level.
2. Slowly add the attenuation using the DIP switches.
3. Reduce the booster's gain by external attenuator or replace with lower gain
antenna if above methods don't work.
Target:
The work is accomplished until Alarm LED is "Green" or "Slow Flashing
Green". Please note that "Green" LED may lead to lower coverage, which can be
improved by adjusting outdoor antenna to get stronger receiving signals.
Measures:
Below options are recommended to eliminate "Quick Flashing Green"
and "Quick Flashing Red".
After all LEDs work fine, check whether the coverage is good or not. If it is good,
the booster system installation is completed. Below actions can be taken if the
coverage is still not good.
1) If the signals in most areas have not been improved, please check below again:
The weak receiving signal leads to the low output signal level. Change the
direction of outdoor antenna or its installation position or replace outdoor
antenna with higher gain antenna to increase receiving signal level.
Check whether it is necessary to add more indoor antennas since barriers
block the signal penetration. Also check whether the booster's power is enough;
Quick Flashing
Green
Quick Flashing
Red
Output power
is not full
Check coverage, leave it as it is if
it is good; if coverage is not good,
please increase receiving signal
level
Not working properly.
Check coverage, leave it as it is if
it is good. Actions must be taken if
coverage is not good or if you don't
feel comfortable about Alarm LED
quick flashing green light.
Alarm
LED
Green
Slow Flashing
Green
Full output
power
Output power
is over rated
The booster
auto shuts off
for protection due
to much over rated
Working properly
https://www.signalbooster.com/ | 1-855-846-2654 | order@signalbooster.com