SETTINGS
Remove the plastic tab from the bottom of the remote control to establish the
battery connection.
On / Off
Press
‘POWER’
to switch the FM radio on / off.
Volume Control
Volume up with
‘VOL+’
or
‘V+’
/ Volume down with
‘VOL-’
or
‘V-’
.
Antenna
The antenna consists of the telescopic antenna, the integrated frame antenna and the
external antenna connection.
- Frame antenna:
The steel casing of the RadioStar Mirror is used.
- Telescopic antenna: A telescopic antenna is mounted on top of the steel casing.
When the antenna is half-extended, it can be clamped.
In most cases, the antenna can be hidden from view.
- External connection: There is an external antenna connection on the base of the
telescopic antenna.
This alternative should only be used if reception is not
satisfactory, even after adjusting the telescopic antenna.
Starting the Station Scan Automatically
Start the station scan by pressing
‘TUN+’
or
‘TUN-’
for approximately 3 seconds.
Starting the Station Scan Manually
Press
‘TUN+’
or
‘TUN-’
in short intervals to adjust the stations manually.
The FM radio reception can be optimized by adjusting the telescopic antenna.
Station Memory with the Control Panel
You can save up to 10 radio station presets. First, select your preferred FM station.
Press
‘TIME’
for 3 seconds, and then select where to save it by pressing
‘PRESET’
repeatedly.
Press
‘TIME’
again to fi nish.
Station Memory with the Remote Control
You can save up to 10 radio station presets. First, select your preferred FM station.
Press
‘TIME’
for 3 seconds, and then select where to save it by pressing the number
buttons
‘1-10’
.
Press
‘TIME’
again to fi nish.
Station Memory Changing
If you try to save a new station under a preset that has already been assigned, the
previous station will be deleted and the new one will be saved in its place.
Selecting Saved Stations
By pressing
‘PRESET’
on the control panel, or by pressing the number buttons
‘1-10’
on the remote control, the saved station will be selected.
Setting the Time Mode 12 / 24 Hours
The clock display can be set in 12 or 24 hours mode. Start by turning off the radio.
Activate the clock mode by pressing
‘TIME’
for 3 seconds. By pressing
‘PRESET’
you can choose between 12 / 24 hours mode. Time will be displayed in the 12 hour
mode if a dot appears in the upper left of the display. You are in 24 hour mode if the
dot is not displayed.
To save the selected time mode, press
‘TIME’
.
Setting the Time
First, turn off the radio.
Activate the clock mode by pressing
‘TIME’
for 3 seconds.
Adjust the minutes by pressing
‘TUN-’
.
Adjust the hours by pressing
‘TUN+’
.
Press
‘TIME’
to save the time.
Setting the Radio Alarm Clock
To have the radio automatically turn on at a specifi c time, the clock must be set fi rst.
Turn off the radio, and activate the radio alarm clock mode by pressing
‘VOL-’
or
‘V-’
for 3 seconds.
Adjust the minutes by pressing
‘TUN-’
. Adjust the hours by pressing
‘TUN+’
.
Press
‘VOL-’
or
‘V-’
to save the turn on time. The radio will turn on automatically to
the most recently used frequency at the selected time.
RadioStar
- 9 -
- 10 -
