6
Installation
It is recommended that this product is installed by two people.
1. Position the mirror in a suitable location
according to the zonal diagram - Fig.
1
, ensuring that the domestic electrical mains supply is within reach of the
electrical entry point of the product.
2. Carefully mark the position of the mirror using a soft pencil ensuring it is level.
3. Remove the mirror and mark the mounting points on the wall,
see Fig. 2
.
Please
ensure that all marked mounting points accurately match up with the
fixing points on the mirror.
4. Using a suitable drill bit, drill holes in the marked positions to a suitable depth. If
drilling through tile, use a ceramic drillbit.
5. Insert wall plugs level with the surface of the wall. If fitting to a tiled surface,
wall plugs should be inserted below the tile surface to avoid cracking.
NB.
For
plasterboard walls, specialist fixings should be purchased, available from any
DIY or hardware store.
6. Screw supplied fixings into wall plugs.
7. Ensure the domestic electrical mains supply to which the mirror is being
connected is turned off.
Connect the domestic mains supply to the terminal
box
according to the wiring diagram on page 3
.
8. Hang the mirror in position.
9. Switch the domestic electrical mains supply for the mirror back on.
NB.
On first use of the charging socket, there may be resistance when inserting the
plug. Make sure that the mirror is held firmly so that it is not pushed off the wall.
After a few uses, resistance will ease and the socket will function as normal.
