①
Mode: M1, M2
②
Heating:
Ⅰ
,
Ⅱ
,
Ⅲ
(red light of the
device is on )
③
Arrows icon “▲” or “▼” will light up as the
corresponding buttons are pressed.
④
Vibration: When the mode is running, the
light will keep illuminating; when stopping
running, the light will be off accordingly.
⑤
Auto: Switch M1 & M2, there will be a beep.
M1: Pressure up/down with vibration massage
M1: Pressure up/down only
⑥
Short press power switch
Power on: There will be a beep with light on of
the device.
Power off: There will be an incessent beep.
⑦
Short press vibration button
Power on: there will be a beep
Power off: there will be two beeps
⑧
1 second flash when plugged in (standby)
The light keeps illuminating when the device is
turned on.
⑨
Laser : when the mode is running, the light
will keep illuminating, when stopping running,
the light will be off accordingly.
⑩
Heating: on/off/switch
( each press is accompanied by a beep; when
the mode is off, there will be two beeps)
Short press to heat from
Ⅰ
to
Ⅲ
, then another
press will turn off the mode if the level is
Ⅲ
.
Up button: long press to inflate(the up arrow icon
will light on); stopping pressing, and the inflation
will end up.
If you continue pressing for over 30 seconds, it
will stop inflating automatically with beeps, but
the arrow icon will still light on.
⑫
Laser: short press to turn on/off
on: a beep off: two beeps
⑬
Down button: Long press to deflate (the down
arrow icon will light on); stopping pressing, and
the deflation will end up.
Introduction for Remote Control
3
EN
Ⅰ Ⅱ Ⅲ
