www.hi-ti.com
29
．．
CARD OUT SNR
The
sensor
for
cards
in
the
card-insert
mechanism. (ENABLE
/
DISABLE)
.
The default setting is
[DISABLE].
However,
once
you
switch [DISABLE] to [ENABLE] and
there are no cards in the Card Input
Hopper, the error message [CARD
OUT] will be shown on the LCD
display. If the [Card Out] message
continues to exist, even after you
have inserted cards into the Card
Input Hopper and restart your
computer,
then
please
switch
[ENABLE] to [DISABLE] and refer to
Chapter 5 Troubleshootin
g→
“The
Error
Message
shown
on
the
Computer
Monitor
and
the
Solutions”
→
“Card out or feeding
error
”
OR
“The Error Message
shown on the LCD Display and the
Solutions”
→
”CARD OUT”. After
above procedures if this error
message still persists, please contact
the HiTi customer service center.
．．
ADF SENSOR SEL
The sensors for card (ADF SENSOR
1/ADF SENSOR 2). When the card
feeding process fails, you can try to
switch ADF SENSOR 1 or ADF
SENSOR 2 for troubleshooting. If the
problem can not be resolved, please
refer to Chapter 5 Troubleshootin
g→
“The Error Message shown on the
Computer
Monitor
and
the
Solutions”
→
“Card out or feeding
error
”
OR
“The Error Message
shown on the LCD Display and the
Solutions”
→
”CARD OUT”. After
above procedures fail and if the card
feeding process still fails, please
contact the HiTi customer service
center.
．
CLEANING MODE
．．
PUT CLEANING KIT &
OPEN
THE
DOOR
&
CLEAN PROCESSING
Please follow the instruction on the
LCD Display. Remove the peel-off
film from the cleaning card. Insert the
cleaning card and open the ribbon
door. Press [OK] button to initiate the
cleaning process.
} }