33
5. Angle Mode
The instrument would enter the Angle Mode automatically
when starting. You can also enter this Mode by pressing „ANG‟
under basic measurement mode. This Mode involves two pages
switched with soft key „F4‟. Their functions are explained as
followed:
On the first page
Save
: save the current angle to the selected file.
After pressing soft key „F1‟, A dialogue box of
„Information‟ appears to the screen asking you to enter „Point
name‟, „Code‟ and „Target Height‟. The natural name of the point
is to add „1‟ to the previous point name. The code entered depends
on your requirements and the target height depends on facts.
Press „ENT‟ to save measurement. P.S. If having not selected file
at first when pressing „Save‟ under Angle Mode, a dialogue box
of „Select File‟ will be on the screen before „information‟. You
may now select file for saving.
When the measurement is out of the scope of compensator,
the instrument will display „Tilt over!‟and the measurement can‟t
be saved.
If the measurement is saved successfully, the instrument
displays box of „Record:*****‟ for 0.5 second and switch back to
the Angle Mode.
Set 0: set horizontal angle to zero
Press soft key „F2‟
The instrument displays:
Now press „ENT‟ to set zero or „ESC‟ to quit.
SetA: Set horizontal angle as desired degree
Press soft key „F3‟ and the instrument enters page of „Set
HA‟
If need to enter 123°45′56″under„°′″‟ (degree minute and
second) mode, then enter 123.4556. The page is as followed:
Set HA
HR
：
123.4556|
B.S
Clear
Enter