24
3.10 Set up the Addictive Constant and the
Multiplying Constant
See reference in 9. Operating Menu.
The setup of addictive and multiplying constants on the
instrument follows “MENU→6. Calibrate &cofig→3.Add
const”.
The constants are already set through strict measurement
when being sold. You don‟t need to adjust the setting. You may
alter the constant after strict measurement (e.g. in
standardization site for baseline being measured by
authenticated units).
3.11 Selecting Data File
The instrument needs large data and creates large data
when it is operated. This data needs to be storied in the system
files of the instrument as a file form. It‟s a good habit that select
the measuring working files before working.
To select data file, see reference in 9. Operating Menu.
Selecting data file on the instrument follows
“MENU→1.Surveying→1.Select file”. It can be also done by
using star (
Besides common measurement mode (Angle, Distance,
Coordinate), you may also enter „select file‟ page by star key (
★
)
under „Set up station‟ (Menu→1.Surveying→2.Station) or „Set
up BBS‟ (Menu→1. Surveying→3. Orientation(BBS)) or „Stake
out XX‟ (Menu→2.Stake out→5.Stake out) pages.
MEA= Measurement File, working for storing data.
COO= Coordinate File, used for retrieving coordinate.
COD= Code File, used for retrieving code.
LSH/LSV = Defined horizontal /vertical alignment file,
working for staking out roadway
Use „▲‟or„▼‟ keys to move indicator „>‟ to the wanted type
of the file and press „Enter‟ soft key to enter the File list as
followed:
Select file
File(.MEA) 1.MEA
>File(.COO)
File(.COD)
File(.LH)
Save
Enter