Type B. tester
3.PTZ control test
：
a. Switch
“
MODE key
”
to get
“
RS485
”
page as below.
b. Push
“
MENU key
”
to entry detail Protocol Setup.
c. Make sure your remote device protocol is setup correctly at first then
configure this as the same.
For example, Protocol
：
PELCO P / ID
：
1 / Baud rate
：
9600
c. Control direction of PTZ camera by
”
direction key
”
and press
“
Up +
Right
”
key for Zoom in and press
“
Down + Left
”
key for Zoom out is
available that vision was shown on monitor presents communication is
correct.
4.Cable test
：
Open or Short circuit test for 2 sets.
a. Switch
“
MODE key
”
to get
“
CABLE TEST
”
page.
b. Connect two end of termination with
“
Cable test terminal
”
to test circuit
status is OK(Short) or NG(Open) as below.
c. 2 testing channels are independently that make sure connect port is
pair at first.
