background image

IMPORTANT SAFETY INSTRUCTIONS 

Duration Per 

Day in Hours

8
6
4
3
2

1 ½

1

½

¼ or less

Sound Level dBA, 

slow response

90
92
95
97

100
102
105
110
115

WARNING:  When using electrical products, basic cautions should always be followed, including the following:

1. Read these instructions. 
2. Keep these instructions safe.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water. 
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions. 
8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including  
amplifiers) that produce heat.
9. An apparatus with Class I construction shall be connected to a mains socket outlet with a protective 
connection. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two 
blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The 
wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult 
an electrician for replacement of the obsolete outlet. 
10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and 
the point they exit from the apparatus.
11. Only use attachments/accessories provided by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the 
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from 
tip-over.
13. The mains plug or appliance coupler is used as the disconnect device and shall remain readily operable. The 
user should allow easy access to any mains plug, mains coupler and mains switch used in conjunction with this 
unit thus making it readily operable. Unplug this apparatus during lightning storms or when unused for long 
periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged 
in any way, such as when power-supply cord or plug is damaged, liquid has been spilled or objects have fallen 
into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been 
dropped.
15. Never break off the ground pin. Connect only to a power supply of the type marked on the unit adjacent to 
the power supply cord.
16. If this product is to be mounted in an equipment rack, rear support should be provided.
17. Note for UK only: If the colours of the wires in the mains lead of this unit do not correspond with the 
terminals in your plug‚ proceed as follows:
    a) The wire that is coloured green and yellow must be connected to the terminal that is marked by the letter 
E‚ the earth symbol‚ coloured green or coloured green and yellow.
    b) The wire that is coloured blue must be connected to the terminal that is marked with the letter N or the 
colour black.
    c) The wire that is coloured brown must be connected to the terminal that is marked with the letter L or 
the colour red.
18.This electrical apparatus should not be exposed to dripping or splashing and care should be taken not to 
place objects containing liquids, such as vases, upon the apparatus.
19. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in 
susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently 
intense noise for a sufficient time.
    The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following 
permissible noise level exposures: According to OSHA, any exposure in 
excess of the above permissible limits could result in some hearing loss. 
Earplugs or protectors to the ear canals or over the ears must be 
worn when operating this amplification system in order to prevent a 
permanent hearing loss, if exposure is in excess of the limits as set 
forth above. To ensure against potentially dangerous exposure to high 
sound pressure levels, it is recommended that all persons exposed to 
equipment capable of producing high sound pressure levels such as this 
amplification system be protected by hearing protectors while this unit 
is in operation.

Summary of Contents for TSM-10A

















Reviews: