iNSTALL
Designed and Engineered in the UK by HH Electronics LTD.
© 2020 HH Electronics Ltd
EN
By turning on your
amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment should not reach your loud speakers. Wait till all system parts have stabilised,
bass
usually a couple of seconds. Similarly when turning off your system always turn down the level controls on your
amplifier and then turn off its power before turning off other equipment
bass
3) Cables:
Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the amplifier load and could cause damage to your complete system.
4) Servicing:
The user should not attempt to service these products. Refer all servicing to qualified service personnel.
1) Unpacking:
HH
On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit from the
factory to your dealer. In the unlikely event that there has been
damage, please re-pack your unit in its original carton and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit should develop a fault, you will
be able to return it to you dealer for rectification securely packed.
2) Amplifier Connection:
In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your system. With all system parts connected, turn on source equipment, tape decks,
cd players, mixers, effects processors etc, BEFORE turning on your amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.
In order to take full advantage of your new product and enjoy long and trouble-free performance, please read this owner's manual carefully, and keep it in a safe place for future reference.
GENERAL INSTRUCTIONS
This product conforms to the requirements of the following European Regulations, Directives & Rules:
RoHS (2011/65/EU), ErP (2009/125/EU).
--------------------------------------------------------------------------------
CE Mark (93/68/EEC), Low Voltage (2014/35/EU), EMC (2014/30/EU),
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal household waste to landfill sites. It must be taken to an approved
recycling centre according to the recommendations of the WEEE (Waste Electrical and Electronic Equi
pment) directive applicable in your country.
http://support.hhelectronics.com/approvals
T
p
he U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the permissible noise level exposure in the chart op osite.
8) Exposure
to extremely high noise levels may cause permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose
some hearing if exposed to sufficiently intense noise for a sufficient time.
The Tessen series are professional specification cabinets designed to give exceptional dynamics, clarity and projection in all applications from clubs to large venues.
4) Unpacking:
Please retain the packing carton and liners in case the unit should need to be returned at any time.
W
,
takes
ait until all system parts have stabilised usually
a couple of seconds.
In order to take full advantage of it and enjoy long and trouble-free performance, please read this owner's manual carefully, and keep it in a safe place for future reference.
1) Read Instructions
carefully before installing or operating this product.
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Earplugs or protectors to the ear canals or over the ears must be worn when
operating this amplification system in order to prevent permanent hearing loss, if exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to
high sound pressure levels, it is recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be protected by hearing protectors while
this unit is in operation.
9) Servicing:
The user should not attempt to service these products. Refer all servicing to qualified service personnel.
3)
All warnings and instructions for these products should be adhered to.
Comply with warnings:
With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFORE turning on your power amplifier. Many products have large transient surges at turn on
and off which can cause damage to your speakers.
Thank you for purchasing an HH Passive Full Range Inclosure.
B
is
,
y turning on your power amplifier LAST and making sure its level control set to minimum any transients from other equipment will not reach your loudspeakers.
2
.
) Retain these instructions
5) Amplifier connection
. In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your sound system.
S
,
imilarly when turning off your system always turn down the level controls on your power amplifier and then turn off its power before turning off other equipment.
6) Cables
s
- never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the amplifier load and could cause damage to your complete system.
To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance please read the operating instructions.
CAUTION:
WARNING:
16
